Environmental Chamber With Danfoss Solenoid

Uses:

Alternating temperature and humidity chamber for electronic and electrical components and materials , auto , chemical metallurgy , quality measurement, research institutes , universities, enterprises and institutions, a variety of electronic parts and other related products strength at high temperature , temperature, thermostat , cycling and alternating hot and humid environment adaptability test storage and use , testing its various performance indicators, product simulation environment testing is essential equipment.

Size:

1.Studio Size:50*75*60 cm (W*H*D)

2.humidity range : 20 perent ~ 98 perent RH ( temperature at 25 celsius degree ~ 80 celsius degree pm) ( can be set )

3.the temperature uniformity : less than about 2 celsius degree ( no load )

4.humidity uniformity : +2 perent -3 perent R.H

5.the temperature fluctuation : about 0.5 celsius degree ( no load )

6.humidity fluctuation : about 2 perent

7.the temperature deviation : less than about 2 celsius degree

8.humidity deviation : less than about 2 perent

9.the cooling rate : 0.7 ~ 1.2 celsius degree / min

10.heating rate : 1.0 ~ 3.0 celsius degree / min

11.the time setting range: 0 to 999 hours

12.alternating temperature range : -40 ~ 150 celsius degree

13.alternating humidity range : 40 perent ~ 98 perent R.H

14.Noise :<65dB Second, heating and cooling rate :

1 → 150 celsius degree room temperature for about 35 minutes ( linear load , about 3 celsius degree / min )

2 → -40 celsius degree ambient temperature of about 55 minutes ( non-linear load , about 1 celsius degree / min )

Product structure:

1.rapid heating and cooling the body as a whole in the form of test chassis structure , the cooling system is located in the lower part of the cabinet , the control system is located in the upper part of the chamber .

2.the end of the duct mezzanine studio , distribution heaters , refrigeration evaporator, fan and other devices ; left side of the chamber has Ф50 cable hole , single- chamber door ( stainless steel door handle embedded )

3.the use of double high-temperature aging silicone rubber seal , which can effectively guarantee the drain chamber temperature

4.with observation windows , anti-frost device and can control lights switch on the door . Multi-layer hollow glass observation window , glue chip inside the conductive film is heated defrost . Philips Lighting lamps imported brands , which can effectively test the full range of observed changes in the working chamber .

Intentions achievements in quality,quality achievements in the future, we will always uphold the " quality first, service first" purpose , intentions you are forever , hard service to your satisfaction .

GB2423.1-89 cryogenic test method , GB2423.2-89 high-temperature test methods , GB2423-93 test D6 alternating hot and humid test method , IEC68-2-30 test method : standards compliance .

Certificate of these machines:

China official 3rd party calibration report

CE certiification

For the package:

1. PP film first

2. Vacuum package

3. PP film again

4. 10mm thickness PU foam to avoid collision

5. stronged plywood case

6. Standard ASLI CASE MARK

Our Main Products:

1) temperature humidity chamber

2) temperature fast change chamber (ESS chamber)

3) thermal shock chamber

4) temperture humidity combined salt spray chamber

5) temperture humidity combined vibration chamber

6) pressure accelerated aging chamber (PCT&HAST chamber)

7) high temperature aging chamber

8) sand and dust tester

9) rain/water spray chamber

10) salt spray chamber

11) UV climate resistant chamber

12) high temperature chamber/muffle furnace

13) vacuum oven

14) high frequency vibration tester

15) mechanical shock and impact tester

16) acceleration mechanical shock tester